Paired this kit with the mishimoto slim 12 inch fan. Works flawlessly! Instructions leave a bit to be desired. If you plan it out, watch a couple YouTube videos on this kit, and research a good ignition signal location for your application, you are set. The thermostat settings were surprisingly easy to set up as well! With a lifetime warranty, and a good reputation, I believe my vehicle is in good hands. Florida summer traffic jams are no longer a stress, and my AC seems to be working even better and cooler!

Seems to work just fine with the 16 inch Mishi heavy duty fan. I didn't use the butt connectors or ring terminals, I soldered and used thicker rings, so I can't speak about the quality of those. Everything seems to be of pretty good quality and it was easy to install (around 2-3 hours including the fan). The most difficult parts are installing the probe (because of it's thickness) and dialing in the temperature.

Let see wiring this up was no problem especially since I had better connectors, so I didn't have to use the ones they send. However, I feel that the main thing this kit lack's is a printed dial so you know where the temperature is set. It was a hassle to get both fans to run at the same time and to cycle as close as possible. Although I must say that's the only reason I gave it a 4star. None the less they work well.

Definitely pricey but it’s nice and has everything I needed to install the fan. The plug on the relay was a bit difficult to get snapped together and I wish there were numerical indicators on the temperature sensor adjustment but overall, a good buy

I was using a coolant sensor to control my electric fan on my 83 mustang. I could not get a reliable sensor that would work and not keep the fan running all of the time after getting up to temp. I purchased this kit and just adjusted it to my thermostat opening temp and it works great. Running down the highway the fan shuts off and lets air speed cool the radiator then when I get into town at lower speeds it kicks on and cools down just like it is supposed to ! Great thing to use if you are running an electric fan.

i install two 6.5" spal fans on this controller and they work just fine. i emailed the company asking about if they will work with two 12" and and they do! amazing controller. also the sensor is easy to install and easy to adjust. the only flawless in the controller that the wires connector the plugs on the controller melted a bit, maybe because I'm keeping the controller in the fusebox and my v8 runs very hot. overall a great controller to buy for your fans

I'm so fed up with poor quality causing service failures in spite of my own best efforts. -fan control uses poor quality connectors and it is extremely difficult to plug in and align all of the blades while plugging it in. Blade's conflict with internal sockets. A simple plug in turned into an hour of fumbling around to achieve marginal results. Extremely disappointing.

Muy buen artículo.

This kit does its job. Given the price though, I’m very disappointed with the included connecting hardware. All of the crimp connectors were so bad that I just threw them out after they didn’t properly crimp to the wires. I don’t think this was user error as I have used plenty of these in the past no problem. The relay’s harness was also exceptionally difficult to seat properly; the terminals were so loose that the male and female ends did not seat as they are supposed to. I ended up having to pull individual wires and reseat them with pliers to ensure a proper fit. The temperature gauge and adjustment screw work well, however. This kit does its job. But for Mishimoto prices I expect their quality to match. This product is not representative of their typical standard of quality.

It did not come with any directions. Hard to figure out what wire goes where. Took my a couple tries to get it right but works perfect now, car does not over heat. The fans turn on right in the middle of the temp gauge but I do have the controller on the lowest setting.