Exactly what it says it is. Very good quality, and very versatile.

I have a lot of router bits, including rabbeting bit sets from many different manufacturers. This is a value laden set, and my first in 1/4" shanks. This shank size is very useful if you are using a handheld router, particularly a medium size router or trim router. You get several cutting heads and a full set of bearings to adjust to different depths. This makes it easy to set the bearing, put them in the router, and get a nice cut. For deep cuts, you usually want to work up slowly so if you are using hardwood you might have to do a few bit swaps. You can easily use them on a full size router table with the included 1/2" adapter. This is the preferred way to perform deep rabbeting cuts since you can adjust the depth with the fence. For end rabbets on boards you might have to use a router table and a sacrificial board alongside a coping sled. The carbide cutters are pretty good, sharp and without flaws on my set. The finish is fine, the shanks are relatively smooth and straight. There's nothing to dislike at this price point.

These work well in a standard 1/4 inch collet American trim router. The set comes with an adapter so you can use the bits in a 1/2 inch collet. The bit I tested with the adapter fit well in a 1/2 inch collet and was balanced and cut cleanly. These are good for cutting slots and rabbets.

Nice set of rabbet/slot router bits with 1/4" shank (which can also be used with 1/2" collet with the included adapter). The quality appears to be good, and the included variable size interchangeable bearings allows this set to be used to create 24 different combinations of slot depths and widths.

This set arrived in a small box with everything packed nicely inside. The bearings all spin pretty well. I don't expect these bits to have a long service life but they should work fine for lower density lumber where you aren't terribly concerned about any tear-out or fraying. There are a lot of similar sets on Amazon and all probably from the same factory (OEM) in China. Best to just buy the least expensive at the time.

Nice set of tools for slotting/rabbiting wood products. Good assortment of sizes for both cutter width and depth. Sharp with a quality appearance. 1/4 inch shanks that are great for smaller routers where these tools will be used the most.

So - using a smaller “handheld” (portable) plunge router - and I’m definitely a router newbie - so I am still trying to get using these right … but so far so good. They seem to be solid and well made, to withstand my beginner’s manhandling. I they cut like they are supposed to male, without any visible wear and tear, or visible flaws.

Great set of router bits nice and sharp good quality bearings. Nice bits for slotting or rabbiting at an affordable price.